Description
ABSTRACT
The project is about fabrication of wheel-barrow, which is fabricated in Mechanical Engineering workshop in Institute of Management and Technology, Enugu.
The report comprises seven chapters.
Chapter one is about the introduction of the wheel.
Chapter two is about the literature review,
Chapter three is about the material selection and analysis/ manufacturing processes.
Chapter four is about construction of the prototype and optimization /maintenance.
Chapter five is about testing one evaluation. Chapter six is about costing analysis conclusion and recommendation while chapter seven talks about references.
TABLE OF CONTENT
Title page
Letter of transmittal
Release page
Approval page
Dedication
Acknowledgment
Abstract
Table of content
CHAPTER ONE
Introduction
At a very early stage, man realized that the means of carrying load about which nature had provided him, has been a problem to him.
He is limited in load he carries, the distance he could carry them and the speed at which he could travel.
As a result of this, standard wheel barrows that are made of materials which can withstand shock were produced. The tyre of the standard wheel-barrow serve as a shock absorber due to the air inside it. ….
CHAPTER TWO
Literature Review
CHAPTER THREE
Material selection and analysis
Manufacturing processes
CHAPTER FOUR
Construction of the prototype
Optimization/ maintenance
CHAPTER FIVE
Testing and evaluation
Costing analysis
CHAPTER SIX
Conclusion and recommendation
Reference